Lattice fence idea for a hot tub can be a good complement to your home. Giving privacy to your hot tub and protection from various elements such as wind. They do not require a lot of deliveries, but require hard work and some commitment to do. But you will end a grid fence that can be used for many years to come. Measure the area around the barrel where you want a fence to find the amount of wood you need to buy. If you need to soften the ground to put the fence, squeeze a foot deep ditch around the barrel and fill it with softer soil or clay. Let it cure a little for a couple of days.
Measure the area, considering that you will need a plank of wood with an insert tip each other that will anchor the grid fence in the ground. The other wooden planks that you need will be nailed diagonally over the thicker rod pieces. And these should be distributed on the fence two inches apart. Create the roof rack with two to three walls, block the areas you want privacy. But leave an open surface so you can get to the hot tub.
24 Photos Gallery of: Hot Tub Lattice Fence Idea
Lay out thicker, longer, rod planks that are 6.5 feet long parallel to each other, spaced two inches apart to measure for the first wall of the fence. The end result of the grid fence will be a cross and across the wood that resembles a tic-tac-toe aboard, nailed together. Use the tape measure to create spacing between the planks. And ensure that the ends of the planks are leveled evenly. Put the other smaller planks that are six feet long next to you. Begin in one corner of the original planks as on the ground. Place one of the smaller planks diagonally across the planks that are already laying down.
Then, remember to leave the extra six inches of wood where the pointers are free from any other wood. As this will be where you put the fence in the ground to anchor it. And also use your cursor to draw a line where you will need to sow the excess wood plank (you will use the excess pieces too diagonally over the other walls of the fence). Continue to fix the planks diagonally, marking where each has to be cut away. Remove planks, and then remove excess wood. Use the hammer to safely nail the less-measured planks to all the pole planks on the ground. Then, use a nail in the center where the planks meet. When you’re done with this wall, it will look like a grid roof.